Table of Contents
Advertisement
Related
ip prefix-list
Commands
output-delay
Set the interpacket delay of successive packets to the same neighbor.
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no
output-delay command.
Parameters
delay
Defaults
Not configured.
Command
ROUTER RIP
Modes
Command
Version 8.3.16.1
History
Usage
This command is intended for low-speed interfaces.
Information
passive-interface
Suppress routing updates on a specified interface.
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface
command.
Parameters
interface
Routing Information Protocol (RIP)
— enters PREFIX-LIST mode and configure a prefix list.
Specify a number of milliseconds as the delay interval. The
range is from 8 to 50.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the following information:
•
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from
1 to 4094.
1123
Advertisement
Table of Contents
