Table of Contents
Advertisement
Usage
This command applies to any physical interface with speed set to 1000/10000.
Information
Related
speed (for 1000/10000/auto interfaces)
Commands
interface.
negotiation auto
flowcontrol
Control how the system responds to and generates 802.3x pause frames on 10G and 40Gig stack units.
Syntax
flowcontrol rx {off | on} tx {off | on} threshold
Parameters
rx on
rx off
tx on
tx off
Defaults
•
•
Command
INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
The globally assigned 48-bit Multicast address 01-80-C2-00-00-01 is used to send
Information
and receive pause frames. To allow full-duplex flow control, stations implementing
Interfaces
NOTE: Starting with the Dell Networking OS version 7.8.1.0, when you use a
copper SFP2 module with catalog number GP-SFP2-1T in the S25P module,
you can manually set its speed with the speed command. When you set the
speed to 10 Mbps or 100 Mbps, you can also execute the duplex command.
— enables or disables auto-negotiation on an interface.
Enter the keywords rx on to process the received flow
control frames on this port. This is the default value for the
receive side.
Enter the keywords rx off to ignore the received flow
control frames on this port.
Enter the keywords tx on to send control frames from this
port to the connected device when a higher rate of traffic is
received. This is the default value on the send side.
Enter the keywords tx off so that flow control frames are
not sent from this port to the connected device when a
higher rate of traffic is received.
rx off
tx off
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— sets the speed on the Base-T Ethernet
559
Advertisement
Table of Contents
