Table of Contents
Advertisement
show lldp neighbors
hello
Configure the rate at which the LLDP control packets are sent to its peer.
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds
Defaults
30 seconds
Command
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
mode
To receive or transmit, set LLDP.
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx
rx
Defaults
Both transmit and receive.
Command
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
Version 9.2(0.0)
History
870
— displays the LLDP neighbors.
Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is from 5 to 180 seconds. The
default is 30 seconds.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the keyword tx to set the mode to transmit.
Enter the keyword rx to set the mode to receive.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Link Layer Discovery Protocol (LLDP)
Advertisement
Table of Contents
