Table of Contents
Advertisement
REMOVE ALL THE PARTS OF YOUR ELLIPTICAL CROSSTRAINER 3600
FORM THE CARTON AND PLACE THEM ON THE FLOOR CAREFULLY.
FOLLOW THESE INSTRUCTIONS CAREFULLY AND IT WILL MAKE IT
EASIER FOR YOU TO ASSEMBLE YOUR ELLIPTICAL
ASSEMBLY INSTRUCTION
1.
A
REAR
STABILIZER
NOTE:
NOTE: This equpment has been supplied
with some Nylon Locknuts.
It is essential that the nuts are
fully tightened onto the bolts,
so that the bolt penetrates
through the nylon insert.
2.
A
POLYFOAM
BLOCK
MOVING
WHEEL
*
SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY.
fitnessfaq.info
GENERAL
ATTACH THE REAR STABILIZER
Rear stabilizer has end caps that can vary in
height to enable you to level the trainer on
uneven floors.
Fix the rear stabilizer to the main frame and
secure, using two carriage bolts, spring washers,
washers and nylon locknuts.
Fix the plastic caps onto the locknut heads.
END CAP
# 8507-10
ATTACH THE FRONT STABILIZER
RIGHT
PEDAL POST
Front stabilizer has moving wheels near each end.
Find a polyfoam block from carton and rest
the right pedal post assembly on it as shown.
Fix the front stabilizer to the main frame and
secure, using two carriage bolts, washers,
spring washers and nylon locknuts.
NOTE: MAKE SURE you fasten the nuts and bolts
NOTE: MAKE SURE
Fix the plastic caps onto the locknut heads.
CROSS
TRAINER 3600.
# 8507-09
# 8507-11
# 8507-96
securely for your safety and comfort when
pedalling.
X4
X4
# 8507-97
*
Hide quick links:
Advertisement
Table of Contents
