Table of Contents
Advertisement
Cautions and Regulatory Compliance Statements for NEBS
Table 5-1
Safety Compliance and NEBS Requirements
Specification
The English warnings in this document are followed by a statement number. To see the translations of a
Note
warning into other languages, look up its statement number in
Information for the Cisco Aggregation Services Router 1000
Cautions and Regulatory Compliance Statements for NEBS
Table 5-2
Equipment-Building System (NEBS) certification from the Telcordia Electromagnetic Compatibility
and Electrical Safety – Generic Criteria for Network Telecommunications Equipment (A Module of
LSSGR, FR-64; TSGR, FR-440; and NEBSFR, FR-2063) Telcordia Technologies Generic
Requirements, GR-1089-CORE.
Table 5-2
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Caution
Caution
Products that have an AC power connection are intended for deployments where an
external surge protective device (SPD) is used at the AC power service equipment as
defined by the National Electric Code (NEC).
This product is designed for a common bonding network (CBN) installation.
This product can be installed in a network telecommunication facility or location
where the NEC applies.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
5-4
Compliance Requirements (continued)
Description
GR-1089
GR-63
lists cautions, regulatory compliance statements, and requirements for the Network
NEBS Compliance Statements
To comply with the Telcordia GR-1089 NEBS standard for
electromagnetic compatibility and safety, for Ethernet RJ-45 ports, use
only shielded Ethernet cables that are grounded on both ends. In a NEBS
installation, all Ethernet ports are limited to intrabuilding wiring.
The intrabuilding ports of the equipment or subassembly is only suitable
for connection to intrabuilding or unexposed wiring or cabling. The
intrabuilding ports of the equipment or subassembly MUST NOT be
metallically connected to interfaces that connect to the OSP or its wiring.
These interfaces are designed for use only as intrabuilding interfaces
(Type 2 or Type 4 ports as described in GR-1089-CORE), and require
isolation from the exposed OSP cabling. The addition of primary
protectors is not sufficient protection in order to connect these interfaces
metallically to OSP wiring.
Chapter 5
Preparing Your Site for Installation
Regulatory, Compliance, and Safety
Series.
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
