Attaching the Cable-Management Bracket
The cable-management brackets for the Cisco ASR 1004 Router contain three independent
cable-management "U" type features with four screws and provides cable dressing of each card module
slots. For Cisco ASR 1000 SIPs, these brackets work in tandem with shared port adapter product feature
cable-management device to allow installation and removal of adjacent cards without the need to remove
cables.
Make certain that the cable-management bracket "U" type feature is facing upwards when you attach it
Note
to the chassis.
Follow these steps to attach the cable-management brackets to both sides of the Cisco ASR 1004 Router
in the equipment rack:
Align the cable-management bracket to the rack-mount bracket on one side of the Cisco ASR 1004
Step 1
Router. The cable-management bracket aligns to the top hole of the chassis rack-mount bracket.
Using a Phillips screwdriver, insert the screw through cable-management bracket and into the chassis
Step 2
rack-mount and tighten the screw.
Figure 7-14
rack.
Figure 7-14
1
Cable-management bracket top and bottom
screw
2
Cable-management bracket and U feature
device
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
7-20
shows where to attach the cable-management brackets to the Cisco ASR 1004 Router in a
Chassis Rack-Mount Bracket Ear Holes for the Cable-Management Bracket
1
3
2
CR IT
MA J
ACT V
PW R
MIN
STB Y
STA T
AS R1 00 0-R
P1
Chapter 7
Cisco ASR 1004 Router Overview and Installation
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
LIN K
CO N
ERN ET
HD
CA RR IER
MGM T ETH
BIT S
USB
DF
DIS K
1
0
1
3
Chassis rack-mount bracket
— —
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
AUX
OL-13208-11