Table of Contents
Advertisement
Connecting Power to Cisco ASR 1004 Router
After you establish normal router operation, you can disconnect the terminal.
Step 2
Connecting the Ethernet Management Port Cable
When using the Fast Ethernet Management port in the default mode (speed-auto and duplex-auto) the
port operates in auto-MDI/MDI-X mode. The port automatically provides the correct signal connectivity
through the Auto-MDI/MDI-X feature. The port automatically senses a crossover or straight-through
cable and adapts to it.
However, when the Fast Ethernet Management port is configured to a fixed speed (10/100/1000 Mbps)
through command-line interface (CLI) commands, the port is forced to MDI mode.
When in a fixed-speed configuration and MDI mode:
•
•
Figure 7-16
Figure 7-16
2
1
Connecting Power to Cisco ASR 1004 Router
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
Warning
When you install the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
7-22
Use a crossover cable to connect to an MDI port
Use a straight-through cable to connect to an MDI-X port
shows the MGMT Ethernet port connector.
Cisco ASR 1000 Series Route Processor MGMT Ethernet Port Connector
CRI T
MAJ
ACT V
PW R
STB Y
MIN
STA T
RP 1
AS R10 00-
MGMT Ethernet port
Chapter 7
SPA -4XO C3-P
OS
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
AUX
LINK
CON
HD
MGM T ETHE
RNET
CAR RIER
BITS
USB
DF
DISK
1
0
1
2
Cable-management bracket and U feature
device
Cisco ASR 1004 Router Overview and Installation
OS
SPA -4XO C3-P
SPA -4XO C3-P
OS
2
SPA -4XO C3-P
OS
OS
SPA -4XO C3-P
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
