Cisco ASR 1002-F Router Components
The Cisco ASR 1002-F Router SPA has three types of LEDs: two LEDs for each port on the SPA and
one STATUS LED, as shown in
Figure 9-8
1
2
Table 9-1
Table 9-1
LED Label
C/A
A/L
STATUS
Cisco Integrated ASR 1002-SIP10-F and SPA for Cisco ASR 1002-F Router Description
The Cisco ASR 1002-SIP10-F in the Cisco ASR 1002-F Router is integrated into the chassis and you
cannot insert or remove it. The Cisco integrated ASR 1002-SIP10-F provides the physical and electrical
termination for one half-height SPA.
The Cisco integrated ASR 1002-SIP10-F interface supports all Cisco SPA interface processor functions
and services. However, the Cisco integrated ASR 1002-SIP10-F differs in the following areas:
•
•
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
9-8
Cisco ASR 1002-F Router SPA Faceplate
1
2
C/A (Carrier/Alarm)
A/L (Active/Loopback)
describes the Cisco ASR 1002-F Router SPA LEDs.
Cisco ASR 1002-F Router SPA LEDs
Color
State
Off
Off
Green
On
Amber
On
Off
Off
Green
On
Amber
On
Off
Off
Green
On
Amber
On
Functions as the base board for the Cisco integrated RP
Is not a field-replaceable unit (FRU) and does not support online insertion and removal (OIR)
Chapter 9
Figure
9-8.
3
SPA STATUS
— —
Meaning
SONET alarm controller is shut down.
Port is enabled by software and there is a valid SONET alarm
signal without any alarms.
Port is enabled by software and there is at least one alarm.
Interface is shut down.
Port is enabled by software and loopback is off.
Port is enabled by software and loopback is on.
SPA power is off.
SPA is ready and operational.
SPA power is on and good and the SPA is being configured.
Cisco ASR 1002-F Router Overview and Installation
3
OL-13208-11