Table of Contents
Advertisement
Installing the Cisco ASR 1002-F Router in a Rack
Two-Post Rack Installation
The Cisco ASR 1002-F Router can be installed on a two-post rack, either a 19-inch or 23-inch rack.
Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches
Note
(48.26 cm). The height of the chassis is 3.47 inches (8.8 cm). Airflow through the chassis is from front
to back.
If you are using a two-post rack, secure the rack to the floor surface to prevent tipping and avoid bodily
Caution
injury and component damage.
Position the chassis so the front is closest to you and lift it carefully into the rack. To prevent injury,
Step 1
avoid any sudden twists or moves.
Figure 9-15
Figure 9-15
1
Step 2
Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on
both sides of the rack.
Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the
Step 3
holes on the rack or mounting strip.
For each bracket, insert and tighten two screws to the rack on both sides.
Step 4
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
9-20
shows the Cisco ASR 1002-F Router on a two-post rack.
Installing the Cisco ASR 1002-F Router on a Two-Post Equipment Rack
2
Rack equipment rail
Chapter 9
Cisco ASR 1002-F Router Overview and Installation
0
1
2
Front rack-mount bracket ear and holes
-POS
SPA-4 XOC3
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router