free hit counter

Cisco ASR 1000 series Hardware Installation Manual page 307

Aggregation services routers
Table of Contents

Advertisement

Chapter 10
Cisco ASR 1002-X Router Overview and Installation
Note
Figure 10-9
3
1
2
Screw the cable management bracket to each side of the rack mount brackets already attached to the
Step 6
chassis. Use two screws for each cable management bracket. Use the packet of four screws.
Verify if all the screws are securely tightened.
Step 7
Go to the
Step 8
Rack-Mounting the Cisco ASR 1002-X Router
The Cisco ASR 1002-X Router can be installed in an existing rack with equipment or in an empty rack
with no equipment. The chassis can be mounted on either of these rack types:
When handling the chassis, always follow proper lifting practices. See the
Note
section on page
OL-13208-11
Ensure that the cable management U feature device has the open end pointing upwards when you
attach it to the chassis
Attaching the Cable Management Brackets to the Cisco ASR 1002-X Router
Cable management bracket top and bottom
screw
Cable management bracket
"Attaching a Chassis Ground Connection" section on page 10-26
Two-post rack, either 19-inch or 23-inch equipment rack. Inner clearance (the width between the
inner sides of the two posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis
is 3.47 inches (8.8 cm). Air flow through the chassis is from front to back.
Four-post, 19-inch equipment rack. Inner clearance (the width between the inner sides of the two
posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches (8.8
cm). Air flow through the chassis is from front to back.
5-23.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
2
1
1
3
Rack-Mounting the Cisco ASR 1002-X Router
Chassis front rack mount bracket
to continue the installation.
"Chassis-Lifting Guidelines"
10-17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asr 1000 series

Table of Contents