Table of Contents
Advertisement
Attaching the Chassis Rack Mount Brackets
The Cisco ASR 1002-X Router can be installed with both front or rear rack mount brackets.
Verifying Rack Dimensions
Before you install the chassis, measure the space between the vertical mounting flanges (rails) on your
equipment rack to verify that the rack conforms to the measurements shown in
Mark and measure the distance between the holes on the left and right mounting rails.
Step 1
The distance should measure 18.31 inches ± 0.06 inches (46.5 cm ± 0.15 cm).
Note
Measure the space between the inner edges of the left front and right front mounting flanges on the
Step 2
equipment rack.
The space must be at least 17.7 inches (45 cm) to accommodate the chassis that is 17.25 inches (43.8 cm)
wide and fits between the mounting posts on the rack.
Figure 10-10
Attaching the Chassis Rack Mount Brackets
This section explains how to attach the front and rear rack mount brackets to the chassis. Before
installing the chassis in the rack, you must install the rack mount brackets on each side of the chassis.
The parts and tools required for installing the rack mount brackets and cable management brackets are
listed in the
The cable management brackets are attached to the chassis after you install the chassis rack mount
Note
brackets on the chassis and mount the chassis in the rack.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
10-18
Measure for pairs of holes near the bottom, middle, and top of the equipment rack to ensure that
the rack posts are parallel.
Verifying the Equipment Rack Dimensions
Mounting flanges
Minimum usable
aperture 17.7 inches
(45.0 cm)
Hole centerline
to hole centerline
18.31 inches ± 0.06 inches
(46.5 cm ± 0.15 cm)
"Tools and Equipment" section on page
Chapter 10
Cisco ASR 1002-X Router Overview and Installation
5-23.
Figure
10-10.
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router