free hit counter

Cisco ASR 1000 series Hardware Installation Manual page 321

Aggregation services routers
Table of Contents

Advertisement

Chapter 10
Cisco ASR 1002-X Router Overview and Installation
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
This unit has two power supply connections. All connections must be removed to de-energize the unit.
Warning
Statement 1028
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than: AC power supplies 20 A and DC power supplies 30 A.
Statement 1005
Connecting AC Input Power to Cisco ASR 1002-X Router
This section provides the procedures for connecting AC-input, –48 VDC input power, and the +24 VDC
input power to your Cisco ASR 1002-X Router.
For detailed instructions for removing and replacing the Cisco ASR 1002-X Router AC and DC power
supplies, see
To connect AC power to the Cisco ASR 1002-X Router, follow these steps:
At the rear of the router, ensure that the power switch is in the Off (O) position.
Step 1
Note
OL-13208-11
Chapter 13, "Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers."
Turn the power switch to the On (|) position after both sides of the power cord are connected.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Cisco ASR 1002-X Router Power Supplies
10-31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Asr 1000 series

Table of Contents