Table of Contents
Advertisement
Connecting Power to the Cisco ASR 1013 Router
Note
A ground cable is required for each DC PDU. We recommend that you use at least 6-AWG
•
multistrand copper wire. This wire is not available from Cisco Systems; it is available from any
commercial cable vendor.
The ground wire cable lug should be dual-hole (as shown in
terminal studs at 0.625 inch (15.88mm) centers. Recommended lug terminal wire size Panduit part
number:
Figure 11-15
End View
0.48
0.08
Note
When you install the unit, the ground connection must always be made first and disconnected last.
Warning
Statement 1046
To connect the DC power supply, follow these steps:
Make certain that the chassis grounding is connected before you begin installing the DC power supply
Step 1
Locate the stud (see
Step 2
must be connected first and follow these steps:
Using the grounding lug, replace the washers and Kepnut screw in the following order.
a.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
11-32
DC input power cables must be connected to the PDU terminal studs in the proper positive
(+) and negative (–) polarity. In some cases, the DC cable leads are labeled, which is a
relatively safe indication of the polarity. However, you must verify the polarity by measuring
the voltage between the DC cable leads. When making the measurement, the positive (+)
lead and the negative (–) lead must always match the (+) and (–) labels on the power
distribution unit.
LCD8-14A-L for 8AWG wire size
–
LCD6-14A-L for 6AWG wire size
–
DC Input Power Cable Lug
Ø 0.267
2 holes
0.25
0.63
To avoid hazardous conditions, all components in the area where DC input power is
accessible must be properly insulated. Therefore, before installing the DC cable lugs, be sure
to insulate the lugs according to the manufacturer's instructions.
Figure
11-16, callout 6) on the DC power supply for the GND connection which
Flat washer
–
Grounding cable lug
–
Chapter 11
All measurements in inches
2.24
Crimp area
0.37
Cisco ASR 1013 Router Overview and Installation
Figure
11-15) and able to fit over M6
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router