Table of Contents
Advertisement
Cisco ASR 1001 Router Description
Table 12-4
Cisco ASR 1001 LEDs
No.
LED Label
LED
1
PWR
Power
2
ACTV
Active
3
STAT
STATUS
4
STBY
Standby
You can upgrade the throughput of the ESP from 2.5 Gbps to 5 Gbps by applying a software-activated
performance upgrade license and then reloading the router. If you want to determine the current
throughput level of the ESP, run the show platform hardware throughput level command. The
following example shows the output of this command before the performance upgrade license is applied:
Router# show platform hardware throughput level
The current throughput level is 2500000 kb/s
The following example shows the output of this command after the performance upgrade license is
applied:
Router# show platform hardware throughput level
The current throughput level is 5000000 kb/s
For more information about the software-activated performance upgrade license, see the Cisco ASR 1000
Series Aggregation Services Routers Release Notes at the following location:
http://www.cisco.com/en/US/docs/routers/asr1000/release/notes/asr1k_rn_rel_notes.html
Power Supplies in the Cisco ASR 1001 Router
The Cisco ASR 1001 Router power supply module supports the following Cisco power supplies:
•
•
The power supply generates +12 V and +5 V, which is distributed to the mainboard and fans. The +5 V
is used to operate the power control devices. It also provides an operational +5 V, as needed.
The power supply units contain one or two fans that are only used for cooling the power supply. Each
power supply is self contained and controls its own fan speed and fan redundancy.
The power supplies are hot pluggable from the rear of the chassis and can be removed or installed while
the system is operating, without affecting any aspect of system performance. The Cisco ASR 1001
Router supports up to seven chassis-mounted cooling fans. Each fan provides an alarm output for error
indication speed measurement. The fans are not field replaceable, but the system can meet the cooling
requirements in the event of a single-fan failure.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
12-14
Color
Solid green
Off
Green
Green
Yellow
Red
None
AC power supply operates between 85 to 264 VAC
–48 VDC power supply input range supported is -40.5 to -72 VDC.
Chapter 12
Cisco ASR 1001 Router Overview and Installation
Behavior Description
All power supplies are within operational limits.
Off. The router is in standby mode.
The embedded services processor is green when
active.
Code has downloaded successfully and is
operational.
BOOT ROM has loaded successfully.
Not booted.
Will always be off.
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router