Cisco ASR 1001 Router Power Supply Installation
This section contains the following topics:
•
•
•
•
The covers are an integral part of the safety design of the product. Do not operate the unit without the
Warning
covers installed. Statement 1077
Warning
When you install the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Installing AC Input Power to Cisco ASR 1001 Router
The Cisco ASR 1001 Router has two AC power supplies in the rear of the chassis. The input receptacle
is an IEC60320 C14 type of filtered AC inlet. The current rating on the connector is 10 A.
Do not install the power supplies with the chassis cover off.
Warning
Figure 12-22
Figure 12-22
Follow these steps to connect an AC input power supply to the Cisco ASR 1001 Router.
Step 1
There are two power supplies installed. At the rear of the chassis, check that the power switch on the
chassis is in the standby position.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
12-34
Installing AC Input Power to Cisco ASR 1001 Router, page 12-34
Removing AC Power Supply from the Cisco ASR 1001 Router, page 12-36
Installing DC Input Power on the Cisco ASR 1001 Router, page 12-38
Removing DC Input Power from the Cisco ASR 1001 Router, page 12-43
shows the Cisco ASR 1001 Router AC power supplies.
Cisco ASR 1001 Router AC Power Supplies
Chapter 12
Cisco ASR 1001 Router Overview and Installation
0
1
OL-13208-11