Table of Contents
Advertisement
Removing and Replacing Cisco ASR 1000 Series Route Processor Internal Hard Drive
Figure 14-2
Figure 14-2
Remove the internal drive cover:
Step 5
a.
Using a # 2 Phillips screwdriver or a flat head screwdriver, loosen the screw fasteners on the cover.
b.
Slide the cover off as shown in
c.
Lift the cover up from the board.
Inspect the existing cables and replace them only if they are damaged. If you do not need to replace
Step 6
them, leave the connection to the Cisco ASR 1000 Series Route Processor 1 in place and only remove
the connection to the internal hard drive.
Step 7
Carefully disconnect the cables at the rear of the hard drive. These cables are tie-wrapped in to prevent
them from disconnecting from the Cisco ASR 1000 Series RP1 itself. If the cables are not damaged,
leave the cables connected to the Cisco ASR 1000 Series RP1 with the tie wrap in place. Remove the old
hard drive.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
14-6
Chapter 14
shows the Cisco ASR1000-RP1 module with the hard drive cover removed.
Cisco ASR1000-RP1 Module Hard Drive Cover and Screw Fastener
Figure
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
2
1
14-2.
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router