Table of Contents
Advertisement
Removing and Replacing the Cisco ASR 1000 Series DIMM Memory Modules
This section describes how to remove the chassis cover and then remove and replace the Cisco ASR 1001
Router DIMM.
Figure 14-20
1
Removing the Cisco ASR 1001 Router DIMMs
Follow these steps to remove the Cisco ASR 1001 Router DIMM:
Step 1
With a wrist strap on, remove the power supplies from the chassis.
Note
For instructions about how to remove the AC and DC power supplies from the Cisco ASR 1001 Router,
see:
•
•
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
14-30
Figure 14-20
shows the location of the DIMM and eUSB in the Cisco ASR 1001 Router.
Cisco ASR 1001 Router Internal Component Location
Cisco ASR 1001 Router DIMM location (four
slots)
The chassis cover cannot be removed until the power supplies are removed from the chassis.
Removing AC Power Supply from the Cisco ASR 1001 Router, page 12-36
Removing DC Input Power from the Cisco ASR 1001 Router, page 12-43
Chapter 14
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
1
2
Cisco ASR 1001 Router eUSB location
2
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router