Table of Contents
Advertisement
Chapter 14
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Remove the small Phillips screw holding the eUSB board in place. See
Step 6
Figure 14-32
1
1
Cisco ASR 1001 router eUSB device Phillips screw
Gently pull the eUSB device up from its connector, and remove it.
Step 7
Place the eUSB device in an antistatic bag for return.
Step 8
You have removed the eUSB device from the Cisco ASR 1001 Router.
To replace the eUSB component into the Cisco ASR 1001 Router, follow these steps:
With the chassis cover removed, align the replacement eUSB device over the connector and standoff.
Step 1
The device fits over the threaded post that sticks up off the board and accepts a screw to hold the eUSB
firmly to the Cisco ASR 1001 chassis base.
OL-13208-11
Cisco ASR 1001 Router eUSB Device
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Removing and Replacing Cisco ASR 1000 Router eUSB Devices
Figure
14-32.
14-43
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router