Chapter 14
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
dir harddisk
To restore data after the internal hard drive replacement, run the following command:
Step 7
archive tar/xtrac tftp:usb0:asr1000.tar harddisk:
You have completed the replacement procedure for the eUSB device in the Cisco ASR 1001 Router.
Removing and Replacing Cisco ASR 1000 Series Router 1 GB
USB Flash Token Memory Stick
The Cisco ASR1000-RPs contain ports for a 1 GB flash token memory stick to store configurations or
Cisco IOS XE consolidated packages.
Figure 14-34
1 GB flash token memory stick.
Figure 14-34
1
2
3
Caution
Do not remove a USB Flash memory module when issuing some file access command or a read/write
operation to the Flash memory module when it is processing. The router might reload or the USB Flash
memory module can be damaged. You can check to see if the USB activity LED on the Cisco
ASR1000-RP front panel is flashing, prior to the removal of the USB device
To remove and then replace a USB 1 GB flash token memory stick from a Cisco ASR1000-RP, follow
these steps:
OL-13208-11
Removing and Replacing Cisco ASR 1000 Series Router 1 GB USB Flash Token Memory Stick
shows the USB port 0 or 1 connector on the Cisco ASR 1000 Series route processor for the
Cisco ASR 1000 Series Route Processor 1 Token Memory Stick Port
CRIT
PWR
ACTV
MAJ
STAT
STBY
MIN
ASR1000-RP1
5
Internal hard drive LED
External USB Flash LED
Internal USB bootflash LED
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
HD
USB
BF
0
1
DISK
4
4
USB0 and USB1 connectors
5
Cisco ASR 1000 Series RP LEDs
— —
1
2
3
14-45