Table of Contents
Advertisement
Removing and Replacing the Cisco ASR 1001 Router Power Supplies
Figure 14-84
Figure 14-84
1
2
Insert the exposed wire of one of the ground wire into the terminal block plug. Make sure that you cannot
Step 7
see any wire lead. Only wire with insulation should extend from the terminal block.
Do not overtorque the terminal block plug captive screws. The recommended maximum torque is from
Caution
0.5 Nm (4.425 lbf in.) to 0.6 Nm (5.310 lbf in.).
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
14-110
shows the DC power supply with lead wires.
DC Power Supply with Lead Wires
Negative (–) lead wire
Positive (+) lead wire
Chapter 14
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
1
2
3
3
Ground lead wire
— —
OL-13208-11
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Cisco ASR 1000 series
Related Products for Cisco ASR 1000 series
- Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router
- Cisco ASR1000-RP2 - ASR 1000 Series Route Processor 2 Router
- Cisco ASR-1000-SIP10
- Cisco ASR 1001
- Cisco ASR1002-5G-SEC/K9 - ASR 1002 VPN+FW Bundle Router
- Cisco ASR1004-20G-SEC/K9 - ASR 1004 VPN+FW Bundle Router
- Cisco ASR1002-10G-VPN/K9 - ASR 1002 VPN Bundle Router
- Cisco ASR1002-5G-HA/K9 - ASR 1002 HA Bundle Router