Table of Contents
Advertisement
BARCODE SCANNING FEATURES
5
TEST MODE
Once entered, the five LEDs are activated and if the scanner starts reading barcodes. The
LEDs indicate the read rate percentage. In case of a NO READ condition, only the Status
LED is on and blinks.
The LEDs indicate the read rate percentage as follows:
To exit the Test Mode, press the X-PRESS push button once.
NOTE: By default, the Test exits automatically after two minutes.
LEARN
Once entered, the LEARN LED blinks and scanner starts a procedure to automatically detect
and recognize barcodes, which are presented to it.
Place a barcode into the scan line and the LEARN LED goes solid for a short time as
Processing and Decoding parameters are successfully saved.
If the calibration cannot be reached after a timeout of about 3 (three) minutes, the scanner
will exit Learn Mode without saving the parameters.
SETUP
Not used at this time.
NETCONFIG
Once entered from a Master scanner in a multi-scanner array (tunnel), the system detects
and identifies Slave scanners in the array. The Slave scanners (and the Master) will then be
available in the User Interface (see chapter 4).
Press the X-Press button once again to exit.
173
- Quick Links:
- Getting Started
Hide quick links:
Advertisement
Table of Contents
