Table of Contents
Advertisement
5
5.6.2 Top-Mounted Barcode Scanner Calibration Using PackTrack
NOTE: It is not possible to illustrate every possible installation angle and
scanner mounting position in this manual. Use the following steps as a
general guide to calibrating each system scanner using barcodes in three
positions. You will need to make adjustments to the label/box position based
on your situation. It is, however, important to note the fixed XYZ coordinates
of the conveyor.
With the belt stopped, measure and enter the barcode XYZ coordinate data for each scanner
as follows:
1. Make sure that the intended scanner (in a multi-head system) has been selected from the
drop-down lists at the top of the wizard window.
2. Start by laying a system barcode on the conveyor bed in the laser line as close to the left
edge (X=0 edge) as possible. See illustration below.
3. Measure the distance for X from the edge of the conveyor bed to the center of the
barcode, and enter that distance in the first box under X-Coord (mm) in the PackTrack
Calibration Wizard.
180
st
Figure 44: Top-read 1
DS8110 REFERENCE MANUAL
barcode placement
- Quick Links:
- Getting Started
Hide quick links:
Advertisement
Table of Contents
