Table of Contents
Advertisement
6
5
4
6
4
5
h. Adjust the drive select lever control cable.
Refer to "ADJUSTING THE DRIVE SELECT
LEVER CONTROL CABLE AND SHIFT
ROD" on page 3-24.
EWA14900
WARNING
After this adjustment is performed, lift the
front and rear wheels off the ground by plac-
ing a block under the engine, and spin the
rear wheels to ensure there is no brake drag.
If any brake drag is noticed perform the
above steps again.
i. Install the front fender inner panel.
Refer to "GENERAL CHASSIS" on page 4-1.
L
LLL
L LLL
L
L LLL
L
L LLL
L
EAS21240
CHECKING THE BRAKE FLUID LEVEL
1. Place the vehicle on a level surface.
TIP
When checking the brake fluid level, make sure
that the top of the brake fluid reservoir top is hor-
izontal.
2. Check:
• Brake fluid level
Below the minimum level mark "a" → Add the
recommended brake fluid to the proper level.
Recommended fluid
DOT 4
L LLL
L
L LLL
L
LLL
3-21
A
a
B
a
A. Front brake
B. Rear brake
EWA13090
WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor lock.
ECA13540
NOTICE
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
TIP
In order to ensure a correct reading of the brake
fluid level, make sure the top of the brake fluid
reservoir is horizontal.
EAS21250
CHECKING THE FRONT BRAKE PADS
The following procedure applies to all of the
brake pads.
CHASSIS
2WD
4WD
Advertisement
Chapters
Table of Contents
Troubleshooting
