Panasonic CQ-VD7001U Operating Instructions Manual page 45
In-dash 7” widescreen color lcd monitor/dvd receiver
Hide thumbs
Also See for CQ-VD7001U:
- Operating instructions manual (93 pages) ,
- Installation manual (9 pages) ,
- Service manual (74 pages)
Table of Contents
Advertisement
SP DELAY
(Speaker delay)
Adjusting the timing with which the audio from each speak-
er reaches the listener's position
(Center speaker delay time set-
CENTER
ting)
]
[
: down,
: up
Setting range: 0 ms to 5 ms (1 ms steps)
(Surround speaker delay time
SURROUND
setting)
]
[
: down,
: up
Setting range: 0 ms to 15 ms (1 ms steps)
¡Make this adjustment while listening to sound.
¡If the speaker setting is
NONE
speaker cannot be selected.
¡When "PRO LOGIC" is displayed, 15 ms are automatically
added to the delay time setting for the surround speakers.
MODE LEVEL
Setting the VTR/AUX input level
Make this setting if it is not possible to adjust the volume
through the connected device (on the output side).
VTR LEVEL
(Setting for VTR)
LOW
: sets the level low/sound volume increases
HIGH
: sets the level high/sound volume decreases
AUX LEVEL
(Setting for AUX)
LOW
: sets the level low/sound volume increases
HIGH
: sets the level high/sound volume decreases
Note:
¡If the input level from VTR/AUX is too high, the audio will
not be output normally.
¡After setting the input level
The volume can be adjusted by pressing [ } ] or [ { ]
(VOL) on the remote control or turning rotary volume
controller on the unit.
: Previous menu
[MENU]
: Previous menu
1 ms = 0.001 seconds
default: 0 ms
1 ms = 0.001 seconds
default: 0 ms
(none) for a speaker, that
default:
HIGH
default:
HIGH
: Quit
[MODE]
: Quit
[]] [[] [}] [{]
LPF/HPF
(Low Pass Filter/High Pass Filter)
Cut off frequency
LPF CUT OFF
(Sub-woofer Low Pass Filter)
]
[
: down,
: up
Setting range:
HPF CUT OFF
(High Pass Filter)
]
[
: down,
: up
Setting range:
,
OFF
Note:
¡This setting is not available if
set to
(on).
ON
¡
(High pass filter) is enabled only on the
HPF CUT OFF
front speakers (R/L) and rear speakers (L/R).
: Select/adjust
: Select/adjust
-
(in 5 Hz step)
60 Hz
160 Hz
default:
100 Hz
-
(in 5 Hz step)
90 Hz
225 Hz
default:
OFF
(SRS setting) is
CS Auto
[ENTER]
: Determine
CQ-VD7001U
44
45
- Quick Links:
- Manual de Instrucciones
- Display Settings
Hide quick links:
Advertisement
Table of Contents
