Removal and Replacement
Replacing an Optical Drive — Jukebox Online
c. Press
or
NEXT
d. Press
or
NEXT
DRV<x> is the number of the drive you are replacing).
e. Press
to select DRV<x> POWER ON. Press
NEXT
15. Download the appropriate firmware into the replacement drive.
16. If a disk was removed from the failed drive, replace the disk into the
drive.
17. Remove power to the drive using the control panel and the following
sequence:
a. Press
or
NEXT
.
ENTER
b. Press
or
NEXT
c. Press
or
NEXT
is the number of the drive you are replacing).
d. Press
to select DRV<x> POWER OFF. Press
NEXT
18. Remove the drive power and cable and service SCSI cable from the
replacement drive. Stow the service SCSI cable.
Reassembly Notes
1. Slide the drive into the drive enclosure and give yourself enough room
to connect the drive interface cable, SCSI cable, and drive power cable
to the rear of the replacement drive (see Figure 5-13).
Stick a clip on the rear of the replacement drive and thread the drive
interface cable into this clip as you mount the cables on the rear of the
drive (see #1 Figure 5-13).
2. Mount the replacement drive into the drive enclosure with four T-10
screws (two on each side).
3. Mount the cable access panel onto the top rear of the drive enclosure
with two T-10 screws (see Figure 5-12).
4. Insert the drive enclosure into the chassis and secure it with the T-20
screw.
5. Route the SCSI cable, drive interface cable, and drive fan power
cables up to the interposer PCA. Connect the cables (see Figure 5-10
5-24
to display DRIVE POWER *. Press
PREV
to display DRV<x> POWER OFF, (where
PREV
until ONLINE DRIVE REPAIR * displays. Press
PREV
to display DRIVE POWER *. Press
PREV
to display DRV<x> POWER ON, (where DRV<x>
PREV
.
ENTER
.
ENTER
.
ENTER
.
ENTER
Chapter 5