Table of Contents
Advertisement
RAS-18UFPX4-T2 / 18UAX4-T2
Power source
50 Hz, 220 V Single phase
Maximum running
16A
current
Plug socket &
fuse rating
2
4 mm
(H07RN-F or 245 IEC 66) or 3.5 mm
Power cord
(AWG-12)
CAUTION
•
Wrong wiring connection may cause some
electrical parts burn out.
•
Be sure to comply with local codes on running
the wire from indoor unit to outdoor unit (size of
wire and wiring method etc.)
•
Every wire must be connected firmly.
NOTE :Connection cable
•
Wire type : More than 1.5 mm
IEC66) or 1.3 mm
2
(AWG-16)
8-6. How to Set Remote Control Selector
RAS-24UFPX4-T / 24UAX4-T
18A
When two indoor units are installed in seperated
rooms, there is no need to change the selector switch.
20A
<Remote control selector switch>
2
• When two indoor units are installed in the same
• The remote control signal is not recived when the
1. Set the remote control selector switch with the
1) Turn the circuit breaker of the main power switch off
2
(H07RN-F or 245
2) Remove the Air inlet grille. (Refer to page 47, 8-4-2)
3) Select the terminal of selector switch from [A
– 55 –
FILE NO. SVM-05015
Switch
room or the adjacent two rooms, they may be
controlled simultaneously with a single remote
control. To prevent this, set either unit and its remote
control to B setting. (Both units are set to A setting
before shipment.)
indoor unit setting is different from the remote
control one.
indoor unit.
before setting the selector switch.
Fig. 8-6-1
position] to [B position].
Fig. 8-6-2
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
