Harman Accentra Installation & Operating Manual page 11
Hide thumbs
Also See for Accentra:
- Installation & operating manual (49 pages) ,
- Owner's manual (32 pages) ,
- How to clean (5 pages)
Table of Contents
Advertisement
ImPOrTANT NOTE: The Accentra is shipped bolted to the
skid through two holes in the cast base plate. If these holes
are not used to lag the unit to the floor these holes must be
filled with the 3/8" x 1/2" hex head bolts provided. (See tag
on bolt bag provided.)
Fig. 14
Skid bolt down holes/floor lag down holes
NOTE: All PACKAgINg & ShIPPINg mATErIAlS
muST bE rEmOvEd FrOm ThE STOvE bEFOrE
OPErATINg.
Optional rubber Pad leveling Feet
Optional kit #1-00-12302 contains 4 rubber pad feet. Used
to raise the bottom edge of the cast base plate off the floor
surface, they ensure that any vibrations caused by motors
and other moving parts will not be transferred by direct
contact. These rubber pads have a threaded stud that
extends through the base plate. The top of the threaded stud
has a screwdriver slot. Therefore, the unit can be leveled
from above inside the unit. The front two are in the right and
left front corners of the firebox. NOTE: The door will need to
be partially closed to access the right leveling pad stud due
to the door hinge.
The rear two studs are to the right and left of the distribution
blower. They are somewhat difficult to reach, therefore, it is
suggested that the rear two pads be adjusted by tilting the unit
slightly forward. Adjust the pads with your fingers and tilt unit
back for fit. Then adjust the front pads for the final clearance.
Leveling/vibration-dampening feet
Fig. 15
3-90-08326R25_06/13
Installation
There is a leg kit available for the Accentra (Item # 1-00-
247211). The four cast iron legs bolt to a plate, and the stove
then sits on the plate. The rubber leveling feet are removed
to allow the stove to fit down over the leg plate. The leg kit
adds 2.95 inches in height. The leg kit can also be used in
conjunction with the cast floor protector. If using with the cast
floor protector, a floor protector cover is also needed since
the legs allow viewing underneath the stove.
dO NOT blOCK Or ObSTruCT ThE ArEA bENEATh
ThE APPlIANCE. ThIS AIrFlOw IS CruCIAl TO SAFE
OPErATION ANd ClEArANCES TO COmbuSTIblES.
Optional leg Kit
Leg Kit includes; four
legs, mounting plate
and hardware.
11
- Quick Links:
- Trouble-Shooting
- Wiring Diagram
- Service Parts
Hide quick links:
Advertisement
Table of Contents
