Harman Accentra Installation & Operating Manual page 9
Hide thumbs
Also See for Accentra:
- Installation & operating manual (49 pages) ,
- Owner's manual (32 pages) ,
- How to clean (5 pages)
Table of Contents
Advertisement
Place the stove on a noncombustible floor surface or floor
protector. This can be a minimum of a 20 gauge sheet metal
plate, ceramic tile with grouted joints, a UL listed stove board,
or a Harman® Cast Iron floor protector. The Harman® Cast
Iron Floor Protector is equal to the minimum dimensions, which
are 24
x 28
.
This allows for a 2" extension on each side
1/16"
5/8"
of the unit (which is actually 6 inches from the window
opening) and a 6" extension to the front (measured from
the window opening also) (3
plate front edge.) The rear edge of the floor protection can
be flush with the cast base plate rear edge.
NOTE for Canadian installation only: Per ULC-S627-00,
If installed on a combustible floor, the need to provide a
noncombustible floor protector covering the area beneath
the space heater and extending at least 17.72" (450mm) on
the firing side and at least 7.87" (200mm) on the other sides.
In Canada, you may follow smaller U.S. floor protection
requirements ONlY if the user agrees to completely
shut-down the appliance, and allow it to cool to where
all fire is extinguished and the combustion blower and
its indicator light shuts off, prior to opening the firebox
door or ash door.
Floor protection is required under any horizontal venting.
This protection must extend 2 inches (5.8cm) beyond each
side of the horizontal pipe.
dO NOT CONNECT TO ANY AIr dISTrIbuTION duCT
Or SYSTEm.
INSTAll vENT AT ClEArANCES SPECIFIEd bY ThE
vENT mANuFACTurEr.
dO NOT uSE mAKEShIFT COmPONENTS Or
COmPrOmISES whEN INSTAllINg ThIS APPlIANCE.
YOur SAFETY IS A SErIOuS CONCErN.
CAuTION
hOT whIlE IN OPErATION.
KEEP ChIldrEN, ClOThINg ANd FurNITurE AwAY.
CONTACT mAY CAuSE SKIN burNS.
3-90-08326R25_06/13
Installation
" if measured from the base
3/8
Floor Protection
requirements
Sides
j
K
Front
l
Rear
NOTE: Measurement
"K" is measured from
the glass in the US
ONLY
Harman® Cast Iron
Floor Protector size:
24
(611mm) X
1/16
j
uSA
28
(727mm)
5/8
US
Canada
6"
200mm
6"
450mm
0"
200mm
l
j
Canada
F
loor protector
K
9
- Quick Links:
- Trouble-Shooting
- Wiring Diagram
- Service Parts
Hide quick links:
Advertisement
Table of Contents
