Preconfiguring A Stack Member - Dell PowerConnect 8024 User Configuration Manual

Table of Contents

Preconfiguring a Stack Member

To preconfigure a stack member before connecting the physical unit to the

stack, use the show support switchtype command to obtain the SID of the

unit to be added.

The example in this section demonstrates pre-configuring a PowerConnect

8024F switch on a stand-alone PowerConnect 8024 switch.

To configure the switch:

1 View the list of SIDs to determine which SID identifies the switch to

preconfigure.

console#show supported switchtype

Switch Mode ID

------ ------------------------- ----------

2 Preconfigure the 8024F switch (SID = 2) as member number 2 in the

console#configure

console(config)#stack

console(config-stack)#member 2 2

console(config-stack)#exit

console(config)#exit

Managing a Switch Stack

Show Quick Links

Table of Contents