Commands - Dell PowerConnect 8024 User Configuration Manual
Hide thumbs
Also See for PowerConnect 8024:
- User configuration manual (1266 pages) ,
- Cli reference manual (1132 pages) ,
- User manual (778 pages)
Table of Contents
Advertisement
Commands
This section provides information about the commands you use to manually
configure and monitor ETS. For more information about the commands, see
PowerConnect 8024/8024F/8132/8132F/8164/8164F CLI Reference
the
Guide
at support.dell.com/manuals. On PC81xx switches, the following steps
are not required if using the DCBX protocol to obtain ETS configuration
from an auto-configuration source. PC80xx and PCM8024-k switches do not
support configuration of ETS parameters. To ensure lossless behavior, the
administrator must perform other configuration steps including creating a
non-default VLAN, configuration ports in trunk mode, enabling PFC and
assigning PFC to the lossless queue.
For information on configuring iSCSI and DCBX, refer to "Configuring
iSCSI Optimization" on page 395.
Command
classofservice traffic-
class-group
traffic-class-group max-
bandwidth
traffic-class-group min-
bandwidth
traffic-class-group strict Activates the strict priority scheduler mode for each
traffic-class-group
weight
show classofservice
traffic-class-group
Purpose
Maps the internal Traffic Class to an internal Traffic Class
Group (TCG). The Traffic Class can range from 0-6,
although the actual number of available traffic classes
depends on the platform.
Specifies the maximum transmission bandwidth limit for
each TCG as a percentage of the interface rate. Also
known as rate shaping, this has the effect of smoothing
temporary traffic bursts over time so that the transmitted
traffic rate is bound.
Specifies the minimum transmission bandwidth
guaranteed for each TCG before processing frames from
lower numbered TCGs on an interface.
specified TCG.
Specifies the scheduling weight for each TCG. The
scheduler attempts to balance the traffic selected for
transmission from the TCGs such that, when the switch is
congested, traffic is selected from the round robin
configured TCGs in proportion to their weights.
Displays the Traffic Class to Traffic Class Group mapping.
Configuring Data Center Bridging Features
835
- Quick Links:
- System Management Features
Hide quick links:
Advertisement
Table of Contents
