Table of Contents
Advertisement
For Parts Call K&T 606-678-9623 or 606-561-4983
SERVICE AND ADJUSTMENTS
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into
contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 15)
Factory assembly has provided lowest handle height. Se lect
handle height best suited for your tilling conditions. Handle
height will be different when tiller digs into soil.
•
If a higher handle height is desired, loosen the four
nuts securing handle panel to engine brackets.
•
Slide handle panel to desired location.
•
Tighten the four nuts securely.
ENGINE
BRACKETS
FIG. 15
TINE ARRANGEMENT
Your outer tines can be assembled in several different ways
to suit your tilling or cultivating needs.
CAUTION: Tines are sharp. Wear
gloves or other protection when han-
dling tines.
NORMAL TILLING - 17" PATH (See Fig. 16)
•
Assemble holes "A" in tine hubs to holes "B" in tine
shaft.
CLEVIS
PIN
A
B
HAIRPIN CLIP
FIG. 16
MID-WIDTH TILLING - 15" PATH (See Fig. 17)
•
NARROW TILLING - 10-1/4" PATH (See Fig. 18)
•
HANDLE
PANEL
NUTS (ALSO 2
ON LEFT SIDE
OF TILLER)
NARROW CULTIVATING - 12-1/2" PATH (See Fig. 19)
•
•
EDGING - 9-5/8" PATH (See Fig. 20)
•
•
OUTER TINE
A
B
INNER TINE
13
www.mymowerparts.com
Assemble holes "A" in tine hubs to holes "C" in tine
shaft.
C
A
FIG. 17
Remove outer tines.
INNER TINES ONLY
FIG. 18
Remove inner tines.
Assemble holes "A" in tine hubs to holes "C" in tine
shaft.
A
C
FIG. 19
Remove inner tines.
Assemble holes "A" in tine hubs to holes "D" in tine
shaft.
A
D
FIG. 20
C
A
C
A
D
A
Advertisement
Table of Contents
