Table of Contents
Advertisement
Installing the Cisco VG310 and Cisco VG320 Voice Gateways
Procedure
Step 1
Attach the short leg of one bracket to the chassis, using two 6-32 × 1/4 slotted hex screws (provided). Use a
plastic washer (provided) with each screw, with the narrow end of the washer fitting into the bracket slot, and
facing the chassis.
Figure 10: Attaching the Brackets for Wall Mounting
Step 2
Attach the second bracket to the opposite side of the chassis.
Step 3
Orient the chassis to ensure that the back panel with connectors faces sideways.
Note
Step 4
Secure the long legs of the brackets to the wall with fasteners that are appropriate for the material that wall
is made of:
a) To hold the unit in place for easy installation, install a starter screw in the wall, and hook the bracket
keyhole over the screw.
b) Secure both brackets to the wall using the fasteners (not supplied).
Note
Note
OL-31292-01
Vertical orientation of the chassis with the back panel connectors facing up or down is not
recommended.
To attach the brackets to a wall stud, each bracket requires two #10 wood screws (round-head or
pan-head) with #10 washers, or two #10 washer-head screws. The screws must be long enough to
penetrate at least 3/4 inch (20 mm) into the supporting wood or metal wall stud.
For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and
washers must be #10.
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide
Mounting the Chassis on a Wall
31
Hide quick links:
Advertisement
Table of Contents
