Table of Contents
Advertisement
Configuring the Cisco VG310 and Cisco VG320 Voice Gateways
The configuration command script is created.
hostname myrouter
enable secret 5 $1$t/Dj$yAeGKviLLZNOBX0b9eifO0 enable password cisco123 line vty 0 4
password cisco snmp-server community public !
no ip routing
!
interface GigabitEthernet0/0
shutdown
no ip address
!
interface GigabitEthernet0/1
no shutdown
ip address 10.10.10.12 255.255.255.0
!
end
Step 12 Respond to the following prompts. Enter 2 to save the initial configuration:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed:
myrouter>
The facility prompts you to save the configuration.
• If you answer no, the configuration information you entered is not saved, and you return to the voice
gateway enable prompt (
• If you answer yes, the configuration is saved, and you are returned to the user EXEC prompt (
Step 13 To save the configuration, enter yes.
The following message is displayed:
Use this configuration? {yes/no} : yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
%LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
%LINK-3-UPDOWN: Interface Ethernet0/1, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0/0, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0/1, changed state to down
%LINK-3-UPDOWN: Interface Serial0/2, changed state to down
%LINK-3-UPDOWN: Interface Serial1/0, changed state to up
%LINK-3-UPDOWN: Interface Serial1/1, changed state to down
%LINK-3-UPDOWN: Interface Serial1/2, changed state to down
<Additional messages omitted.>
Step 14 When the messages stop appearing on your screen, press Return to get the
The
Router>
At this stage, you have the following two options:
• Run the setup command facility again, and create another configuration:
Router> enable
Password: password
Router# setup
OL-31292-01
Subnet mask for this interface [255.0.0.0] : 255.255.255.0
Class A network is 10.0.0.0, 24 subnet bits; mask is /24
Router#
prompt indicates that you are now at the CLI and you have just completed the initial configuration.
Cisco VG310 and Cisco VG320 Voice Gateways Hardware Installation Guide
). Enter setup to return to the System Configuration dialog box.
Using the setup Command Facility
Router>
prompt.
Router>
).
57
Hide quick links:
Advertisement
Table of Contents
