Table of Contents
Advertisement
Step 5
Starting at the top of the following table, find your symptom and follow the instructions
given in the Action column.
Symptom
The operator panel power LED does not come
on, or comes on and does not stay on.
The system stops with the Diagnostic Operating
Instructions displayed.
The system stops with a prompt to enter a
password.
The system stops with a three, four or
eight-digit error code(s) displayed on the
console.
The system login prompt is displayed.
The system does not respond when the
password is entered.
188
S80 and S85 User's Guide
Action
Check the power cable to the outlet. Check the
circuit breakers and check for power at the
outlet.
Assure the room temperature is within 60 -
90°F.
If you do not find a problem, record error code
M0PS0000 and report the problem to the
service organization.
Go to Step 6.
Enter the password. You cannot continue until a
correct password has been entered. When you
have entered a valid password, wait for one of
the other conditions to occur.
Refer to "Error Codes" on page 191 and see if
your error code is listed. If it is, perform the
recommended action. If the error code is not
listed, report the error code to your service
representative.
You may not have pressed the correct key or
you may not have pressed the key soon
enough when you were to indicate a Service
Mode boot of diagnostic programs. If this was
the case, start over at the beginning of this
step.
If you are sure you pressed the correct key in a
timely manner go to Step 7.
Go to Step 7.
Advertisement
Chapters
Table of Contents
