Table of Contents
Advertisement
I
NSTALLING THE PHOTOCONDUCTOR BELT MODULE
1.
Make sure all packing materials and tape are removed from the printer.
2.
Open the Front Cover of the printer by grasping in the Front Cover Release latch (A).
3.
Open the Top Cover of the printer by sliding the Top Cover Release button forward (B)
4.
Flip up the photoconductor belt module Locking Levers inside the printer (C).
5.
Remove the Tension Release Pins from both sides of the photoconductor belt module (D).
6.
Remove the black protective sheet from around the photoconductor belt module.
7.
Slide the photoconductor belt module into the guides, as shown (E). (The flat side of the module should face
the front of the printer.)
8.
Snap the photoconductor belt module Locking Levers into place (F).
9.
Close the Top Cover and then the Front Cover of the printer.
note:
The photoconductor belt module is sometimes called the Photoconcuctor photoconductor belt module or
OPC Unit.
A
D
10
SuperScript 4400 — Maintenance Guide
B
E
C
F
Caution
The photoconductor belt
module should slide easly into the
printer. Do not force it!
Advertisement
Chapters
Table of Contents
