After Changing The Jets - Miele CS 1013-1 Operating And Installation Instructions

Hide thumbs Also See for CS 1013-1:

Table of Contents

After changing the jets

^ Reassemble the burner parts in the

reverse order.

^ Check all gas fittings for leaks by

operating the burner without the

upper section of the hob in place

(use a match to ignite the flame).

^ Remove the loose burner parts again.

^ Replace the upper section of the

hob.

^ Screw the burner bases into place,

and replace the other parts of the

burner. Take care to reassemble the

different parts in the correct order.

^ Replace the control knobs.

^ Finally ignite all the burners to check

that they are operating correctly.

The flame must not go out on the lowest

setting, or when the control is turned

quickly from a high to a low setting.

On the highest setting, the flame must

have a distinctive and visible core.

^ Stick the label supplied with the jets

above the label stating the type of

gas being used.

Conversion to another type of gas

Table of Contents