Table of Contents
Advertisement
Presentation Mode
This programs the imager to work in Presentation mode. The LEDs are either
off or at the lowest power for ambient conditions until a bar code is presented to
the imager. Then the LEDs turn on automatically to read the code. Presentation
Mode uses ambient light to detect the bar codes. If the light level in the room is
not high enough, Presentation Mode may not work properly.
Presentation Mode
Presentation LED Behavior after Decode
When an imager is in presentation mode, the LEDs remain on and continue
scanning for a short time after a bar code is decoded. If you wish to turn the
LEDs off immediately after a bar code is decoded, scan the LEDs Off bar code,
below. (If you want the LEDs to remain off for a length of time after the decode,
Default = LEDs On.
use
Presentation LED
Time-Out, below.)
* LEDs On
LEDs Off
Presentation LED Time-Out
When using
Presentation LED Behavior after Decode
(above), you may want to
set the time the LEDs remain off after a decode. To set the duration of this delay,
scan the bar code below, then set the time-out by scanning digits (0 - 9,999 ms)
from the
Programming Chart
on the inside the back cover of this manual, then
scanning Save. Once the unit has completed this time-out, it will immediately
resume scanning.
LED Time-Out Duration
4 - 9
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
