Setup Tab - QSC TouchMix-8 User Manual
Hide thumbs
Also See for TouchMix-8:
- User manual (71 pages) ,
- Technical notes (2 pages) ,
- User manual (134 pages)
Table of Contents
Advertisement
Setup Tab
Name the Aux Output:
Type new name
Touch to enter a new name for the output. (not available on Main output) to name the output.
Link
Linking:
Available only on Auxes 1-8 (TouchMix-16), and 1-4 (TouchMix-8). This Links odd-to-even pairs of auxiliary mixes to create a stereo mix.
Delay In
Delay:
Delay is most commonly used for remote fill speakers. The objective is to set the delay so that the sound from the primary system arrives at the
listeners ears just slightly (20 – 30 msec) ahead of the sound from the fill system. When done correctly, the listeners perceive the sound as coming
from the primary system even though most of what they hear is from the fill speakers.
In venues with very deep stages, the engineer will sometimes delay the house system so that it time aligns with the back-line. In other words, set up
the system so that the sound from the actual kick drum and the reinforced kick drum arrive at the listeners' ears at the same time.
You can also drive your drummer nuts by delaying his monitor just a bit – but that wouldn't be very nice, would it?
The delay provides a read out in msecs. (up to 100), meters (up to 34.3) and feet (up to 113).
Speaker Settings:
Speaker Settings
Refer to
"Level-Match Your QSC Speakers" on page 12
GXD Amp Settings:
GXD Amp Settings
Refer to
"Output Channel – QSC GXD Amplifier Settings" on page 45
Aux Pick-off
Pre All
Available for the Aux mixes only, these buttons determine where the point from which the signal is taken is before or after the channel fader. For most
monitor mixing applications, this should be set to Pre.
Assignments
Mute 1
And you didn't think there would be any assignments. But these aren't the kind of assignments that require homework. These buttons assign the
output to a Mute Group or a DCA Group. Mute Groups and DCA Groups are discussed previously.
TD-000472-00-B
for details.
Pre Dyn
Pre Fader
DCA 3
Post Fader
16
- Quick Links:
- Touchmix™ How to
- Connecting Remote Devices
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
