Page 3
Congratulations on your new wood-burning stove, which will be a comfortable source of heat to enjoy for many years on end. With its unique design you can view the Black Diamond from all corners of the room. When designing this fireplace we took particular care regarding the ease of use, the operational safety and the design.
Installation It is common practice for the dealer where you purchased your Black Diamond stove to also take care of installing it. If this is not the case, please ensure that the installation is done by a certified installer. A certified installer can also give you the right advice about the flue tube to which the stove must be connected.
Your installer can give you more information about this. When you light the Black Diamond for the first time, the hearth must still ‘anneal’ and temper itself. The unit has a heat resistant lacquer which must burn in the stove at temperatures above 400 °Celsius. This will happen during the first few times of lighting the stove and temperatures rise to 600 °C.
The Black Diamond only burns on wood. Do not put more than 3 to 4 kg of fuel in the stove at the time. Always use clean and cut logs, which have sufficiently dried. Please see the above list for drying times. Wet wood does not burn well and gives heavy smoke emission.
tion and burdens the environment unnecessarily. • Ventilate the space well when you have the stove on. A crackling fire has a minimum air consumption of 25 cubic metres an hour. Never put on your cooking hood when you have a stove burning in the same space. •...
Have the sealing of doors and glass panes checked for wear and tear. Safety A WANDERS wood-burning stove gives you a comfortable and a safe source of heat in your home. Fire safety starts with a proper installation and a properly working flue tube. Your installer must therefore comply with the installation instructions as listed on page 22 and further.
Installation Instructions Black Diamond and Black Diamond Compact The Black Diamond is tested in accordance with the international EN 13240 standardization, and has an extra additional standardization for optimally environment-friendly heating devices related to flue gases (Section 15a B-Vg.
Connecting the hearth The Black Diamond is a heavy woodstove. The standing model weighs 150 kg, including the 2 metre flue tube. Verify whether the wall or the floor onto which the stove is installed is strong enough to hold the weight.
2. Check the packaging of the stove and the base. Do not mount the stove or the base that has been damaged in the box. If there is any damage, please report to WANDERS. 3. Be careful when unpacking the stove and protect the floor while unpacking: the mouth of the tube underneath the stove has a sharp edge.
Repairs Replacing the glass in the door • Open the door with the broken glass. • Remove the glass strips on the inside of the door. • Replace the glass. Be careful, the glass may be sharp! • Check if the ceramic strip is undamaged and properly fixed to the door. •...
If heating circumstances are favourable: calculate according to DIN 4701 In less favourable circumstances: 135 (Black Diamond) 000 (Compact) m In unfavourable circumstances: 95 (Black Diamond) 000 (Compact) m For temporary heating you may assume a reduction of 25% for the volume to be heated if the interval is...
Page 15
Table for thickness of insulation cf thickness of the wall Wall thickness 10 Insulation Convection house Protection of the wall Walls made of combustable construction parts Back side 8 cm Supporting walls in steel construction Integrated pieces against stove On the side Integrated pieces in the wall behind 8 cm Other walls...
Page 20
De garantie vervalt and change of owner. The guarantee is also disclaimed par WANDERS , d’un défaut d’ e ntretien et en cas où le poêle serait Installateur, Vernachlässigung des Ofens und bei einem ook bij gebruik van een verkeerde brandstof.