Table of Contents
Advertisement
On cleaning
Clean the player casing with a soft cloth slightly
moistened with water or a mild detergent
Troubleshooting
solution. Do not use any type of abrasive pad.
scouring powder or solvent such as alcohol or
benzene as it may mar the finish of the casing.
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
General
The operation
buttons do not function.
Press the RESET button.
No sound.
* Rotate the L dial clockwise to adjust the
volume.
l
Cancel the ATT function.
l
Set the fader control to the center position for
a 2.streaker svstem.
The contents
of the memory have been
erased.
l
The RESET button has been pressed.
-Store
again into the memory.
l
The power cord or battery has been
disconnected.
l
The power cord is not connected properly.
No beep sound.
The beep sound is canceled (page 51).
Indications
disappear from/do not appear in
the display.
l
The clock display disappears if you press
m
for 2 seconds.
+ Press m
again for 2 seconds to
display the clock.
l
Remove the front panel and clean the
connectors. See "Cleaning the connectors"
on nage 55 for details.
Stored stations
and correct time are erased.
The fuse has blown.
Makes noise when the ignition
key is in the
ON, ACC, or OFF position.
The leads are not matched correctly with the
car's accessory power connector.
No Dower is being supplied
to the unit.
l
Check the connection. If everything is in
order, check the fuse.
l
The car does not have an ACC oosition.
+ Press (?ZKiKF)
to turn on the unit.
The power is continuously
supplied
to the
unit.
The car does not have an ACC position.
-+ Press K7FF) for 2 seconds.
The power antenna does not extend.
The newer antenna does not have a relax box.
continue
to next page -+
61
Advertisement
Table of Contents
