Table of Contents
Advertisement
6. High quality picture:
(a) 2H type vertical enhancer for greater picture sharpness
(b) Chroma averaging circuit for better color signal-to-noise ratio
(c) Minimum of aliasing on fine objects
(d) Expanded dynamic range by use of knee circuit
(e) Highlight aperture correction for greater picture detail of bright objects
7. Ability to shoot indoor scenes with fixed iris lens by use of Electronic Light Control (ELC)
function.
i Left Button (
This button is used to move the cursor to the left. It also selects the mode and can be
used to adjust some levels.
o Up Button (
This button is used to move the cursor upward. It is also used to select items in the
CAM SET UP menu.
!0 Set Button (
This button is used to activate an item selected in the CAM SET UP menu.
!1 , !3 Selector (NC)
This selector is not used on this camera.
!2 Detail Level Selector (SOFT-SHARP)
This selector is used to select the detail / aperture level as follows.
SOFT: When a quad system is connected to this camera, select this position.
SHARP: Select this position usually.
!4 Power indicator
This indicator lights up when the power of this camera is on.
!5 Monitor Output Connector (MONITOR OUT)
This connector is used to connect with the video input connector of the monitor.
!6 Video Output Connector (VIDEO OUT)
This connector is used to connect a coaxial cable to the camera input connector of the
specified monitor or camera drive unit, to receive DC power and vertical drive pulse,
and supply the video output of the camera.
!7 Rear Cover
The rear cover can be removed, if you require.
Mounting the Lens
Caution:
Before you mount the lens, loosen the screw on the side of the camera, and rotate this
ring clockwise until it stops. If the ring is not at the end, the inner glass or CCD image
sensor may be damaged.
1. Mount the lens by turning it clockwise
on the lens mount of the camera.
2. Connect the lens cable to the auto iris
lens connector on the side of the cam-
era.
Caution for Mounting the Lens
The lens mount should be a CS-mount (1"-32UN) and the lens weight should be less than
450 g (0.99 lbs). If the lens is heavier, both the lens and camera should be secured by
using the supporter.
The protrusion at the rear of the lens should be as shown below:
)
)
)
Rear Panel
ALC Connector
CS-mount: Less than 8 mm (5/16")
Screw
Advertisement
Table of Contents
