Table of Contents
Advertisement
6.
To remove the Back Display Cover, remove the three M2.5x4 Screws securing the Back
Display Cover to the Display Hinges (Figure 4-36).
Figure 4-36 Removing the three back display cover screws
4.13.2 Installing the Gas Plasma Display
1.
If necessary, install the Back Display Cover and secure it in place with the three M2.5x4
Screws (Figure 4-36).
2
Connect the DC-DC Converter Cable to the Gas Plasma Display (Figure 4-35). Secure
the DC-DC Converter to the Back Display Cover with the two Screws. Make sure you
connect the Ground Cable with the bottom screw.
3.
Connect the Gas Plasma Display Cables and the Brightness Control Cable to the Gas
Plasma Display (Figure 4-34).
4.
Secure the Gas Plasma Display and the Ground Cable to the Back Display Cover with
the seven M2.5x4 Screws (Figure 4-33).
5.
Install the Brightness Control Board with the single M2.5x4 Screw (Figure 4-32).
4-35
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
