Table of Contents
Advertisement
Installation
Self-tapping screw
4
. . . . . . . . . . .
(05xl8mm)
caver
Installation board, etc.
l
'
(thickness : 15 mm or more)
Self-tapping screws
Mounting
(03 x 8
mm)
Hardware
I. Install the installation frttrngs rn the unit.
2. Attach the unit.
3. Install the termrnal cover.
1 ACAUTION
1
l
Do not Install in the below locations;
(Unstable locatron, In a locatron that interferes wrth driving, In a location that gets wet, In a
dusty locatron, In a place that gets hot, In a place that gets direct sunlight, In a location that
gets hrt by hot air)
l
Do not Install the unit under the carpet, Otherwise
heat build-up occurs and the unrt may be
damaged.
l
Install this unit in a location whrch allows heat to easily drssrpate.
Once installed, do not place any object on top of the unit.
l
The surface temperature
of the amplifier will become hot during use. Install the amplifier in a
place where people, resins, and other substances that are sensitive to heat will not come into
contact with rt.
l
When making a hole under a seat, rnsrde the trunk, or somewhere
else in the vehicle, check
that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe, or
wrrtng harness, and be careful not to cause scratches or other damage.
l
Do not rnstall near the dashboard, rear tray, or air bag safety parts.
l
The rnstallatron to the vehicle should securely fasten the unit to a place in which it will not
obstruct driving, If the unit comes off due to a shock and hits a person or safety part, it may
cause injury or an accident.
l
After rnstalling the unit, check to make sure that electrical equipment
such as the brake lamps,
turn signal lamps and windshield
wipers operate normally.
English
3
- Quick Links:
- Installation
- Specifications
Hide quick links:
Advertisement
Table of Contents
