Common Registries For Single Side Printers / Dual Side Printers - Toshiba TRST-A10 User Manual
Pos printer opos control
Hide thumbs
Also See for TRST-A10:
- Maintenance manual (42 pages) ,
- Owner's manual (32 pages) ,
- Product description (29 pages)
Table of Contents
Advertisement
TRST-A10/TRST-A15 POS Printer OPOS Control Application User's Manual
Common Registries for Single Side Printers / Dual Side Printers
Service
Description
Version
DeviceName
Port
(*1)
BaudRate
(*2)
VendorID
(*3)
ProductID
(*3)
InputInterface
(*3)
OutputInterface
(*3)
InputEndPoint
(*3)
OutputEndPoint
(*3)
Override
Country
PaperWidthMode
BitmapAspect
PrintBarCodeMode
WatchEndedThreadTimeout
UnKownRetryCount
UnKownRetryTimeout
Filename of Service Object
Brief explanation of Service Object
Version number of Service Object
Connected device
Name of communication port
Can be set from the Control Panel.
Communication speed
Can be set from the Control Panel.
Should be consistent with the baud rate setting of the device.
Vendor ID of the USB device
Product ID of the USB device
Specifies an interface to be used for inputting data from a USB device
Specifies an interface to be used for outputting data from a USB device
Specifies an end point to be used for inputting data from a USB device
Specifies an end point to be used for outputting data from a USB
device
For Left90/Right90 Rotation Print, specifies whether or not standard
characters are to be printed on two lines which are used for printing
double height characters.
Off:
Not printed
On:
Printed
Can be set from the Control Panel.
Country code
Can be set from the Control Panel.
Type of paper by paper width
0:
80 mm
1:
58 mm
Can be set from the Control Panel.
Should be consistent with the paper width setting of the device.
Bitmap aspect ratio setting
0:
Not supproted
1:
Fixed
Specifies the print mode for bar code printing.
When "TEC" is specified, the print width of bar code is determined
based on the ratio of width specified by the Width parameter to the
paper width.
When "Standard" is selected, the print width of bar code is determined
by comparing the print width speficied by the Width parameter to the
width of bar code to be printed.
(For details, refer to the section "Limitations and Precautions" in this
chapter.)
Timeout for forced thread termination
Specifies whether or not a retry process is to be performed when a
(*3)
connection with the device fails due to Unknow. When this item is not
contained in the registry list, no values are given, or something other
than a numeric value is specified, zero (0) is selected as a default.
0: Retry process is not executed for Unknown (Default)
Other than 0:
Effective only when a value other than zero (0) is set for
(*3)
Retry process is executed for UnKnown
TOSHIBA TEC CORPORATION EAA-02450
34
Hide quick links:
Advertisement
Table of Contents
