Mac Access-Group - D-Link DWL-8500AP Command Reference Manual
Dws-3000 series/ unified wired & wireless access system
Hide thumbs
Also See for DWL-8500AP:
- Administrator's manual (168 pages) ,
- User manual (270 pages) ,
- Configuration manual (61 pages)
Table of Contents
Advertisement
CLI Command Reference
The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields,
respectively, of the VLAN tag. For packets containing a double VLAN tag, this is the first (or
outer) tag.
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed
of user configurable queues available for the hardware platform. The
is valid only for a
The
assign-queue
NOTE:
Format
Mode
mac access-group
This command attaches a specific MAC Access Control List (ACL) identified by
interface in a given direction. The
ACL.
An optional sequence number may be specified to indicate the order of this mac access list
relative to other mac access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for this
interface and direction, the specified mac access list replaces the currently attached mac access
list using that sequence number. If the sequence number is not specified for this command, a
sequence number that is one greater than the highest sequence number currently in use for this
interface and direction is used.
This command specified in 'Interface Config' mode only affects a single interface, whereas the
'Global Config' mode setting is applied to all interfaces. The 'Interface Config' mode command
is only available on platforms that support independent per-port class of service queue
configuration.
Format
Modes
no mac access-group
This command removes a MAC ACL identified by
direction.
Format
Modes
248
© 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
rule.
permit
and
redirect
The special command form
Ethernet layer 2 packets, and is the equivalent of the IP access list "match
every" rule.
{deny|permit} {<srcmac> | any} {<dstmac> | any} [<ethertypekey>
| <0x0600-0xFFFF>] [vlan {eq <0-4095>}] [cos <0-7>] [[log]
[assign-queue <queue-id>]]
Mac-Access-List Config
mac access-group <name> in [sequence <1-4294967295>]
Global Config
Interface Config
no mac access-list <name> in
Global Config
Interface Config
value is 0-(n-1), where n is the number
<queue-id>
parameters are only valid for a
{deny | permit} any any
parameter must be the name of an existing MAC
<name>
<name>
parameter
assign-queue
rule.
permit
is used to match all
<name>
from the interface in a given
to an
Hide quick links:
Advertisement
Table of Contents
