Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
FOR THERMADOR
DW246UB / DW246UW / DW246US
Please read this entire instruction manual before proceeding.
IMPORTANT
:
INSTALLER:
OWNER:
WARNING:
AVERTISSEMENT: Couper le courant evant d'instalier.
®
BUILT -IN DISHWASHERS
Models:
DW244UB / DW244UW
DW245UB / DW245UW
DWI246UB / DWI246UW
Local codes vary. Installation, electrical connections, circuit breakers
and grounding must comply with all applicable codes. Save these
instructions for the Local Electrical Inspector's use.
Please leave these Installation Instructions with this unit for the
owner.
Please retain these instructions for future reference.
Disconnect power at the breaker before installing.
Advertisement
Table of Contents
Related Manuals for Thermador DW244UB
Summary of Contents for Thermador DW244UB
-
Page 1: Installation Instructions
INSTALLATION INSTRUCTIONS ® FOR THERMADOR BUILT -IN DISHWASHERS Models: DW244UB / DW244UW DW245UB / DW245UW DW246UB / DW246UW / DW246US DWI246UB / DWI246UW Please read this entire instruction manual before proceeding. IMPORTANT Local codes vary. Installation, electrical connections, circuit breakers and grounding must comply with all applicable codes. -
Page 2: Table Of Contents
Quick Reference Index Introduction ....................1 Tools Needed For Installation ..............1 Materials You Will Need ................1 Accessory Parts Supplied ..............1, 2 Technical Data .................... 2 Choosing The Location ................2 Preparing The Location ................3 Hot Water Supply ..................3 Drain Hose .................... -
Page 3: Introduction
Tools Needed For Installation Introduction Please read these installation instructions completely and carefully. They will save you time and effort and help to ensure optimum dishwasher performance. Be sure to observe all listed warnings and cautions. These installation instructions are intended for use by qualified installers. -
Page 4: Technical Data
Technical Data " (570 mm) 90° 90° " - 24" (600 - 610 mm) Figure 4 3 /8 " (60mm) If the dishwasher is to be installed in a corner, make sure there is adequate clearance to open the door. See Figure 5. -
Page 5: Preparing The Location
Preparing the Location Openings for electrical, water and drain lines must be installed in the marked area as shown in Figures 6 and 7 to avoid interference with the dishwasher frame or other components. Shut-off valve 20 1/2" (520 mm) "... -
Page 6: Inspecting The Dishwasher
If the hole is cut in a metal cabinet, the edge of the hole must be covered by a grommet. Run flexible, as codes Mounting bracket bent permit, cable from junction through hole in cabinet. for mounting to side of cabinet Cable should extend 30”... -
Page 7: Drain Hose
Drain Hose If the 7 foot drain hose provided is not long enough, an Mounting brackets additional piece of hose is needed to connect the drain hose to the sink, disposer or air gap. The rubber drain hose must be resistant to heat and detergent. The drain hose may be obtained from a plumbing, hardware or automotive supply outlet. -
Page 8: Connecting Hot Water Supply
Typical drain connections are shown in Figures 12, 13 Connecting the Hot Water Supply Line and 14. Figure 12 shows typical connection. Figures 13 The hot water supply line should be flushed to clear and 14 show possible connections when an air gap is any foreign material BEFORE connecting the dishwasher. -
Page 9: Connecting Electrical Supply
Connecting the Electrical Supply connected to the equipment grounding terminal or lead The electrical supply must be 120 volt, 60 Hz, 12 ampere, on the dishwasher. The dishwasher must be properly properly grounded. Connect with copper wire only. grounded before operating. Make sure that the dishwasher is connected to a suitable ground in compliance with the NATIONAL ELECTRICAL CODE, WARNING... -
Page 10: Accessory Panel Installation
Pictograms 1 size that may be used is shown in Figure 19. and 2 on the template. Then proceed with Pictogram 3: Thermador offers both a black (Model DWF24UB and Pictogram 3 on template white (DWF24UW) frame kit to complement your... -
Page 11: Door Tension Adjustment
Door Tension Adjustment After installation of the dishwasher open and close the door several times. The door should open and close easily with very little force required to lift the door when fully open. If the door closes too quickly, or if the door falls open the spring tension should be adjusted. - Page 12 Consult with a heating and ventilating engineer for your specific ventilation requirements. We reserve the right to change specifications or design without notice. Some models are certified for use in Canada. Thermador is not responsible for products which are transported from the U.S. for use in Canada. Check with your local Canadian distributor or dealer.