Installing The Device - Panasonic CF-37 Series Reference Manual
Hide thumbs
Also See for CF-37 Series:
- Reference manual (64 pages) ,
- Operating instructions manual (29 pages) ,
- Supplementary instructions manual (17 pages)
Table of Contents
Advertisement
CD-ROM/DVD-ROM Drive
Setting a disc
<CD-ROM Drive>
Label-side up
2
C e n t e r
Holder
Eject Button
<DVD-ROM Drive>
Label-side up
2
C e n t e r
Holder
Eject Button
1
Open the tray
Press the eject button and slowly pull out the tray.
2
Installing the device
Insert the disc at an angle from the front edge label-side up.
2
Push down until the center holder clicks.
Removing the device
Place a finger on the center holder and lift up on the edge of the disc.
3
Close the tray
Close the tray without touching the eject button.
CAUTION
Do not apply excessive force to the tray in the open position, doing so could
damage the tray.
Power-saving mode
If the CD-ROM/DVD-ROM drive has not been accessed within 30 seconds (in the case
of CD-ROM drive), 90 seconds (in the case of CF-VDD372) or 120 seconds (in the
case of CF-VDD371), the drive motor will automatically shut down to reduce the power
consumption. When the CD-ROM/DVD-ROM drive is accessed once again, the power
of the drive motor is turned on. However, approximately 30 seconds are required until
data is actually read from the disc.
NOTE
If the vibration of the CD-ROM/DVD-ROM drive is excessive, set the [CD-ROM/
DVD-ROM Drive Speed] to [Low] in the Setup Utility.
Windows NT
When a CD-ROM or a DVD-ROM is being used, the Power Management Func-
tion operates following the settings of the Setup Utility. It is possible to tempo-
rarily disable the settings by pressing
Fn +
F8 .
35
Advertisement
Table of Contents
