Table of Contents
Advertisement
3. Position the left and right front bagger baffles inside
the mower and secure with screws into the retainer
nuts (Fig. 39).
4. Position the left and right rear discharge baffles inside
the mower. Secure with screws and washers through
the bottom and carriage bolts inside of mower rear
discharge. Secure carriage bolts with locknuts (Fig.
39).
2
4
5
Figure 39
1. Bagger baffle
2. Retainer nut
3. Cap screw
4. Discharge baffle
Important
All bagging baffles and discharge baffles
must be in place when bagging.
Operating with Bagger
When operating the mower with bagger baffles installed
you must engage the blower drive belt.
1. Stop the engine, remove the key.
2. Ensure belt is around blower, idler and PTO gearbox.
3. Push up on the spring loaded idler arm, behind blower
on lefthand side of unit, to relax pressure on clevis pin
(Fig. 40).
4. Remove hairpin cotter and clevis pin from slot in
frame and allow idler down, to tension belt (Fig. 40).
7
3
1
6
m–5272
5. Carriage bolt
6. Lock nut
7. Washer
5. Install hairpin cotter and clevis pin in outer hole of
idler arm for storage (Fig. 40).
4
Figure 40
1. Idler arm
2. Frame slot
Installing and Removing the
Plenum
To avoid damage to the plenum, remove the plenum when
not in bagging mode.
Caution
Hands and fingers can be cut when removing
bagging components.
• Keep hands and fingers out of blower housing.
• Do not operate in bagging mode without entire
bagging system in place.
• Stop engine before cleaning bagging system.
Removing the Plenum
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
key.
2. Tilt deck to upright position. Refer to Tilting the
Mower on page 19.
3. Reach through from lefthand side in front of traction
tire, lift plenum and unwind cable clockwise around
plenum cable guide.
26
2
3
1
m–3548
3. Clevis pin
4. Hairpin cotter
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
