Table of Contents
Advertisement
Data Recovery and General System Information
Verifying the Repair
1. Were you sent here after completing a concurrent maintenance procedure?
2. Go to "Verify Dedicated Repair.".
Verify Dedicated Repair.
1. Perform the following:
2. Select the IPL type and mode that the customer uses (see iSeries Service
3. Start an IPL by powering on the system (see "Powering On and Powering Off
4. Use the service action log to look for any system reference codes (SRCs) that
5. Is the SRC the same as the original SRC?
920
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
b. Select the End Licensed Internal Code option.
Note: Remember that the file does not close until you select the End Licensed
Internal Code option.
This ends the procedure.
No
Yes
↓
Go to "Verify Concurrent Repair" on page 921.
This ends the procedure.
This ends the procedure.
a. Verify that the power cable is plugged into the power outlet.
b. Verify that power is available at the customer's power outlet.
Functions in "Powering On and Powering Off the System and Logical
Partitions" on page 922).
Note: If you select Normal mode when you power on the system, the Dedicated
service tools option will not be shown.
the System and Logical Partitions" on page 922).
Did the system complete the IPL?
Yes
No
↓
This may be a new problem. Go to "Starting Point for All Problems" on
page 4.
This ends the procedure.
are related to this IPL (see "Using the Service Action Log" on page 9).
Are there any SRCs that are related to this IPL?
Yes
No
↓
Perform the "Verification Procedures" (in the Hardware Service
Manager chapter) in the iSeries Service Functions information to verify
that the problem is corrected.
The verification procedures only cover removable media,
communications and diskette problems.
Then return the system to the customer.
Ensure that the customer verifies the system date and time.
This ends the procedure.
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
