Test Print - Sharp AR-C360P Service Manual
Hide thumbs
Also See for AR-C360P:
- Job management manual (220 pages) ,
- Utility manual (188 pages) ,
- Software configuration manual (181 pages)
Table of Contents
Advertisement
5.1.2.5 Test Print
This self-diagnostic routine is used to print the test pattern in the PU. Other test patterns are stored
in the controller.
1.
Continue to press the [MENU+] and [MENU-] keys until "TEST PRINT" appears at the top
row of the display, and the system is in the self-diagnosis (Lever 1) mode. The [MENU+]
key = Increment Test Item / the [MENU-] key = Decrement Test Item.
2.
Press the [ENTER] key only for the setting item applied for test printing appears at the
bottom of the display. Press the [MENU+] and [MENU-] keys until the applicable item
appears. The [MENU+] key = Increment Item / the [MENU-] key = Decrement Item. (Go
to Item 5 to [Default Setting] if setting of each item is unnecessary.)
3.
Press the [ENTER] key for the setting item to appear on the top row of the display and
the setting value to appear at the bottom row of the display. Press the [MENU+] key for
the setting value to increment. Press the [MENU-] key for the setting value to decrement
(the final display setting value is applied). Accordingly repeat item 3.
TEST PATTERN
1
Display
PRINT EXECUTE
TEST PATTERN
CASSETTE
PAGE
COLOR
DUPLEX
JOB OFFSET
FINISHER
*1 TRAY 2 to TRAY 5 and DUPLEX will be displayed only when their respective units are installed.
*2 If the finisher is not installed, "OUTPUT BIN" is displayed and only the output bin is selectable.
• Presets: FACE DOWN/FACE UP
* These settings are valid in the test mode only (they will not be written to the EEPROM).
Rev. 1
Setting value
Press [Enter] to start printing or [CANCEL] to stop printing (each page).
0
0: Blank page
1 to 7: See the "Test Print Pattern" table (pattern printing).
8 to 15: Blank page
TRAY1
Choose a paper feeder.
TRAY2
TRAY3
TRAY4
TRAY5
MPF
0
Set the number of test print pages. Press [ONLINE] to move
the cursor to the digit to be edited. Press [MENU_] to increase
the set value, and [MENU_] to decrease the set value.
ON
Choose Color or Monochrome.
OFF
3 PAGES STACK
Prints on both sides of a stack of 3 sheets.
OFF
Turns off duplex printing.
1 PAGES STACK
Prints on both sides of one sheet.
OFF
Turns the job offset function on and off.
ON
OUTPUT BIN
Choose an output bin.
PUNCH
Turns the punch mode on and off.
OFFSET
Turns the offset mode on and off.
STAPLE
Choose the staple location.
STAPLE PAGE
Set the number of sheets to be stapled (0 to 50).
INVERT
Turns the invert mode on and off.
The settings shaded in
Function
Default: FACE DOWN
are default settings.
104 /
Advertisement
Table of Contents
Troubleshooting
